# Firmware Lifecycle

Note

If Site has Enapter Gateway it needs to be updated to version 1.8.9.

# Change Log

# New Features

  • Allow to Monitor and manage the Dryer from any Electrolyser in the Dryer Control Network (DCN) using Modbus TCP interface. To learn more check the Latest Modbus TCP Interface paragraph for Dryer registers.

# Compatibility Matrix

Please carefully check the compatibility matrix for the 3.2.0 firmware version with the previous version.

Legend:

  • C - fully compatible;
  • NC - not compatible;
  • PC - partly compatible, check additional notes.
3.1.1
OTA Upgradable C
Rollback C

# Known Bugs List

The list below contains the most important problems in the firmware and their solutions.

  • Unable to perform the Factory Settings Reset when the Dryer Control Network (DCN) wasn't created and the Dryer can't connect to a WiFi router.

    No need since FW 3.3.0.

    Solution: make sure you have another WiFi router to which the Dryer will be able to connect. After that scan the QR code of the Dryer with the Enapter Mobile App, enter SSID and password of the new WiFi router. Make sure the Dryer is online in the Enapter Cloud. After that you could perform the Factory Settings Reset.

  • Unable to perform the Factory Settings Reset when the Dryer Control Network (DCN) was created and the Dryer can't connect to a WiFi router.

    No need since FW 3.3.0.

    Solution: make sure the WiFi router to which the Dryer was initially connected is available and the Dryer is able to connect to it, otherwise it is impossible to perform the Factory Settings Reset.